Answered

Welcome to Westonci.ca, your ultimate destination for finding answers to a wide range of questions from experts. Join our platform to connect with experts ready to provide precise answers to your questions in different areas. Get quick and reliable solutions to your questions from a community of experienced experts on our platform.

1) Use SolidWorks (SW) FEA to apply a bending load of 600 lbf on the right end of the stepped shaft as shown below. This is the same geometry as H01. Estimate stress concentration factor Kt for bending from your FEA. Provide a hardcopy color plot of your FEA showing maximum von Mises stress.

Sagot :

Solution :

Given :

L = 1 in

d = 0.75 in

D = 1 in

Fillet radius, r = 0.063 in

[tex]$K_{t_{bending}=\frac{\sigma_{FEA_{bending }}}{\sigma_{Nominal_{bending }}}$[/tex]

We know that :

[tex]$\sigma_{b} = \frac{32M}{\pi d^3}$[/tex]

[tex]$\sigma_{b} = \frac{32 \times (2998.63 \times 25.4)}{\pi (0.75 \times 25.4)^3}$[/tex]

    [tex]$=112.27 \ N/mm^2$[/tex]

[tex]$\sigma_{FEA} = 1.3 \times 10^8 \ N/m^2$[/tex]

         [tex]$=1.3 \times 10^8 \times 10^{-6}$[/tex]

         [tex]$=1.3 \times 10^2$[/tex]   MPa

         = 130 MPa

Therefore, the stress concentration factor is :

[tex]$k_t=\frac{130}{112.27}$[/tex]

   = 1.157922

View image AbsorbingMan
Thanks for using our platform. We're always here to provide accurate and up-to-date answers to all your queries. Your visit means a lot to us. Don't hesitate to return for more reliable answers to any questions you may have. Thank you for trusting Westonci.ca. Don't forget to revisit us for more accurate and insightful answers.